ماژول وایرلس SE8R01 با فرکانس 2.4GHz
14 عدد موجودی عدد موجودی
اخطار: آخرین موجودی
تاریخ تقریبی موجودی:
Note: This product is similar to the NRF24L01 + 2.4G wireless module
The SE8R01 is a single chip 2.4GHz transceiver with an embedded baseband protocol engine, suitable for ultralow power wireless applications. The SE8R01 is designed for operation in the world wide ISM frequency band at 2.400 – 2.4835GHz.
To design a radio system with the SE8R01, you simply need an MCU (microcontroller) and a few external passive components.
You can operate and configure the SE8R01 through a Serial Peripheral Interface (SPI). The register map, which is accessible through the SPI, contains all configuration registers in the SE8R01 and is accessible in all operation modes of the chip.
The embedded baseband protocol engine is based on packet communication and supports various modes from manual operation to advanced autonomous protocol operation. Internal FIFOs ensure a smooth data flow between the radio front end and the system’s MCU. Protocol engine reduces system cost by handling all the high speed link layer operations.
The radio front end uses GFSK modulation. It has user configurable parameters like frequency channel, output power and air data rate.SE8R01 supports an air data rate of 500kbps, 1Mbps and 2Mbps. The high air data rates combined with two power saving modes make the SE8R01 very suitable for ultralow power designs.
Features of the SE8R01 include:
Worldwide 2.4GHz ISM band operation 126 RF channels Common RX and TX interface GFSK modulation 500kbps, 1 and 2Mbps air data rate 1MHz non-overlapping channel spacing at 1Mbps 2MHz non-overlapping channel spacing at 2Mbps
ProgrammAble output power: 0, -6, -12 or -18dBm。(6dBm@3V) 16.5mA at 0dBm output power
Fast AGC for improved dynamic range Integrated channel filters 18.5mA at 2Mbps -83dBm sensitivity at 2Mbps -88dBm sensitivity at 1Mbps -88dBm sensitivity at 500kbps
Fully integrated synthesizer No external loop filer, VCO varactor diode or resonator Accepts low cost ±60ppm 16MHz crystal
1 to 32 bytes dynamic payload length AutomAtic packet handling Auto packet transaction handling 6 data pipe for 1:6 star networks
Integrated voltage regulator 1.8 to 3.6V supply range Idle modes with fast start-up times for advanced power mAnagement 30uA Standby-I mode,4uA power down mode Max 2ms start-up from power down mode Max 210us start-up from standby-I mode
4-pin hardware SPI Max 10Mbps 3 separate 32 bytes TX and RX FIFOs 5V tolerant IO
Same as in NRF24L01+ as shown in the picture or in the table below
PIN SIGNAL PIN SIGNAL
1 GND 2 VCC
3 CE 4 CSN
5 SCK 6 MOSI
7 MISO 8 IRQ