ماژول شارژر / دشارژر باتری لیتیومی دارای خروجی / ورودی 5V 1A مناسب برای ساخت پاوربانک

New Arrivals integrated mobile power chip
First, the performance:
1, the charging input: 5V1A
2, the chip output: 5V1A
Second, the interface:
1, an input interface: MICRO USB female port
2, the output interface: standard USB female port
Third, the size measurements:
L * W * H 50 * 20 * 10mm
Weight: 8g
IV Applicable battery:
Polymer lithium battery, 18650 lithium batteries, cell phone batteries, 3.7V standard lithium battery, single (piece) power supply, can also be multi-section (sheet) parallel power supply. (In parallel to increase capacity)
Unavailable: batteries, battery, 1.2V rechargeable batteries, nickel hydrogen batteries, lithium iron polymer lithium batteries, and do not use multi-series!
Five indicator:
Charging: red light.
Full: green.
Load: blue lights.
NOTE: The chip itself is already onboard SMD LED lights, six expansion port can also be extrapolated as a LED display.
Note: The lithium battery cathode connected to B +, lithium negative electrode connected to B-, any time reverse batteries are likely to burn circuit, burning of the circuit can not be maintained!
Six identification circuit:
Currently the chip directly supports IPHONE and other devices need to be charged to identify cell phone charging
Seven protection board:
Lithium battery protection board, anti-overcharge and over discharge.
Eight, standby loss:
Quiescent current is extremely small, it does not require the installation of the switch.
Nine, use:
After the first powered, no output, you need to use 5V voltage charging port or MICRO USB 5V input port to activate it.
X. Warranty:

prompt:
1. The lithium battery positive and negative connection booster plate must not be reversed, otherwise it will burn board!
2. If the battery is good then is not energized, the boost panels charge can be activated!
3. The booster plate connected battery after power, not the hand element on the touch pad!