ماژول تشخیص زاویه XD-79A

use:

Various angle sensor, dumping sensing, tilt sensor, 2 outputs control.

Module Features:

1, the use of the company's SW-520D highly sensitive tilt sensor

2, the comparator output signals clean, good waveform, driving ability, than 15mA.
3, distribution position sensitivity adjustment
4, the working voltage of 3.3V-12V
5, the output form: digital switching output (0 and 1)
6, a fixed bolt hole for easy installation
7, small PCB board size: 3.2cm x 1.7cm
8, using a wide voltage comparator LM393

Module Description:

1. The initial state of the output from the two depends on the tilt sensor is turned on and off, when turned on, the green light, the output low, the tilt sensor is disconnected, the green light is off, the output high;
2. In the initial state general inclination sensor are installed in the normally open state, the tilt sensor is not in working condition, extend the service life;
3. Default SW-520D dump sensors for object detection 90 degrees for the other point of view, please contact the treasurer.
4, the output can be directly connected to the microcontroller through the microcontroller to detect high and low, thereby detecting the angle of environmental change;
5, the output of the relay module can directly drive the shop, which can be composed of a high-power angle control switch;
Shipping list:
2-way tilt sensor module 1, with two S-520D tilt sensor
Schematic