ماژول وایرلس SE8R01 با فرکانس 2.4GHz

Note: This product is similar to the NRF24L01 + 2.4G wireless module
-----------------
Product Description
The SE8R01 is a single chip 2.4GHz transceiver with an embedded baseband protocol engine, suitable for ultralow power wireless applications. The SE8R01 is designed for operation in the world wide ISM frequency band at 2.400 – 2.4835GHz.
To design a radio system with the SE8R01, you simply need an MCU (microcontroller) and a few external passive components.
You can operate and configure the SE8R01 through a Serial Peripheral Interface (SPI). The register map, which is accessible through the SPI, contains all configuration registers in the SE8R01 and is accessible in all operation modes of the chip.
The embedded baseband protocol engine is based on packet communication and supports various modes from manual operation to advanced autonomous protocol operation. Internal FIFOs ensure a smooth data flow between the radio front end and the system’s MCU. Protocol engine reduces system cost by handling all the high speed link layer operations.
The radio front end uses GFSK modulation. It has user configurable parameters like frequency channel, output power and air data rate.SE8R01 supports an air data rate of 500kbps, 1Mbps and 2Mbps. The high air data rates combined with two power saving modes make the SE8R01 very suitable for ultralow power designs.
Features of the SE8R01 include:
Radio

      Worldwide 2.4GHz ISM band operation   126 RF channels   Common RX and TX interface   GFSK modulation   500kbps, 1 and 2Mbps air data rate   1MHz non-overlapping channel spacing at 1Mbps   2MHz non-overlapping channel spacing at 2Mbps

Transmitter

      ProgrammAble output power: 0, -6, -12 or -18dBm。(6dBm@3V)   16.5mA at 0dBm output power

Receiver

      Fast AGC for improved dynamic range   Integrated channel filters   18.5mA at 2Mbps   -83dBm sensitivity at 2Mbps   -88dBm sensitivity at 1Mbps   -88dBm sensitivity at 500kbps

RF Synthesizer

      Fully integrated synthesizer   No external loop filer, VCO varactor diode or resonator   Accepts low cost ±60ppm 16MHz crystal

Protocol engine

      1 to 32 bytes dynamic payload length   AutomAtic packet handling   Auto packet transaction handling   6 data pipe for 1:6 star networks

Power management

      Integrated voltage regulator   1.8 to 3.6V supply range   Idle modes with fast start-up times for advanced power mAnagement   30uA Standby-I mode,4uA power down mode   Max 2ms start-up from power down mode   Max 210us start-up from standby-I mode

Host Interface

      4-pin hardware SPI   Max 10Mbps   3 separate 32 bytes TX and RX FIFOs   5V tolerant IO

Pinouts

Same as in NRF24L01+ as shown in the picture or in the table below
PIN     SIGNAL     PIN     SIGNAL
1     GND               2     VCC
3     CE                  4     CSN
5     SCK                6     MOSI
7     MISO              8     IRQ